SUTHERLAND 2000 Rub Tester Operation Guide

Follow the image guide below to learn how to use your SUTHERLAND 2000 Rub Tester. 

Step 1

Prepare the test strips of material from the same shipment of stock used in the test sample.

Cleanly cut 2" by 5-1/4" (50mm x 135mm) strips for the 2-pound weight.

2" x 7" (50mm by 177mm) strips for the 4-pound weight (if necessary).

Step 2

Danilee test-specimen-2

The 2" by 5-1/4" (50mm x 135mm) strips are placed face up against the endpin of the scoring device (wooden block), on top of the wires (as shown).

Then 'scored' using the micarta-scoring tool at the red dot positions.

This will facilitate bending the strip to conform to the test weight

Step 3

Bend the test strip at the 'scores', this will help it lie flat on the weight.

Step 4

The test strip should be placed under one clip with the scoring lined up with the edge of the weight.

Smooth the test strip across the bottom of the weight and attach the other end under the opposite clip.

Step 5

Place your 2 5/8" x 6" (66mm by 150mm) printed stock test specimen on the base pad of the unit.

A small piece of tape may be used to secure the specimen to the base unit if necessary

Step 6

Place the weight (with the test strip attached) on the arm of the unit by slipping the hook into the arm over the pin.

The weight should lay flat on the test specimen

The machine should NOT be running

Step 7

Use the "count" button to select the number of strokes desired.

Pressing the button will start the count.

Holding the count button down, the machine will count in increments of 1 until it reaches 10

The machine will then count in increments of 10 until it reaches 100

When the button is released, the machine will count in increments of one again, following the same sequence mentioned previously.

Use the 'select speed' button to choose speed 1, 2, 3, or 4

The small light at the tip if the black button will indicate the speed chosen

Press the 'start' button to begin the test

The unit will countdown the strokes to 000, then it will automatically reset to the count just entered.

Remove the weight and examine the test specimen

相关产品链接：SUTHERLAND 2000磨擦测试仪     SUTHERLAND 2000双磨擦测试仪

如需了解更多Danilee产品，欢迎访问https://ibetter.com/danilee